Stone waxing

Stone stone industry is facing the problem of maintenance, most of the lesions occur after installation, and the resulting stone commercial disputes. The on-site personnel and building owners to install the most likely direct encounter such problems, so when seeking the cause of the issue of stone, its focus is often concentrated in the construction workers are using the unqualified aggregate, stone installation whether the shoddy work, stone construction method is appropriate. The suppliers of raw materials for stone stone processing plants that are not easily considered, at best, only think of the quality of the stone may be defective. Of course, the lesions occur most directly associated with the stone and the stone construction of factors of course, the quality of the relevant law and protection. However, there are many stone disease from occurring, the real factors derived from the stone slab of the processing procedure, that is, the board of the processing procedures, and sometimes indirectly obstacles to conservation projects, and to solve problems arising from the follow-up Sometimes the imagination than the average consumer the trouble. Such as these stone processing problems caused by improper fact the probability is high, but have not been valued by the people. Therefore, stone processing plant for the general problem most likely caused by a process - waxing, we have to analyze the advantages and disadvantages. And recommended protective stone stone processing plant processes to consider in its standard manufacturing processes, or could be considered independent and professional stone to build the factory protection to carry out protective works perfect stone.
Stone is a natural building materials, its surface due to variations in the process of stone formation factors thin lines (commonly known as chicken lines) and the gloss is not ideal, and therefore, production plants often use various methods to improve the surface gloss of stone, lower stone surface of the small fine lines and thin lines. At present, the most commonly used stone processing plant is the completion of the grinding stone surface marked with a layer of wax, the finished product will increase surface gloss of stone, but also reduce the stone surface of the chicken lines, such as improving the surface appearance carried out on the stone house in the waxing process, which is convenient (Stone waxing the surface coverage, the stone does not require high degree of drying required, the processing equipment is simple and cheap), and affordable (low cost wax material But on the stone surface to improve profits after the large). However, construction and installation of the consumers and the industry may cause great distress, mainly due to: the wax as a surface protection material, when its coverage of the surface of the stone, the stone surface of the original pores and fine lines are is blocked, therefore, stone or stone installation industry protection industry, if you want the stone protection works, already in the stone surface of the wax but is within the protective stone penetrated the biggest obstacle remaining is the result of the surface protective layer can not penetrate to the stone below the surface, possible failure and subsequent protection lesions greatly increased the risk, in this case if the soft end of the ground wet stone pavement construction method, the laying of the stone and is often not dense material (such as light granite, etc.), this way, the base water spot after localized lesions of the water is almost inevitable. In addition, after stone after waxing, there are many long-term exposure to air and sun, prone to yellowing phenomenon may be occurring stone yellowing of the primary factor.